ACTIONTEC ELECTRONICS, INC.

DESKVOICE 33.6K, DESKTALK 33.6K

Card Type

Modem (asynchronous)

Chipset

Unidentified

I/O Options

Speakerphone (on DeskTalk only), voice, microphone in, speaker out

Maximum Data Rate

33.6Kbps

Maximum Fax Rate

14.4Kbps

Data Modulation

Bell 103A, 212A

ITU-T V.21, V.22, V.22bis, V.23, V.32, V.32bis, V.34

Fax Modulation

ITU-T V.17, V.21CH2, V.27ter, V.29

Error Correction/Compression

MNP5, V.42, V.42bis

Fax Class

Class I

Data Bus

16-bit ISA

Card Size

Full height, half length

CONNECTIONS

Function

Label

Function

Label

Telephone line in

CN1

Microphone in

CN3

Telephone line out

CN2

Speaker out

CN4

INTERRUPT SELECTION

Setting

JP2/A

JP2/B

JP2/C

JP2/D

JP2/E

JP2/F

JP2/G

3

Closed

Open

Open

Open

Open

Open

Open

4

Open

Closed

Open

Open

Open

Open

Open

5

Open

Open

Closed

Open

Open

Open

Open

7

Open

Open

Open

Closed

Open

Open

Open

10

Open

Open

Open

Open

Closed

Open

Open

11

Open

Open

Open

Open

Open

Closed

Open

12

Open

Open

Open

Open

Open

Open

Closed

í Plug-N-Play

Closed

Closed

Closed

Closed

Closed

Closed

Closed

PLUG-N-PLAY

Setting

JP2/H

JP2/I

JP2/J

í Enabled

Closed

Closed

Closed

Disabled

Open

Open

Open

SERIAL PORT ADDRESS SELECTION

Setting

JP1/A

JP1/B

JP1/C

JP1/D

3F8h (COM1:)

Open

Open

Closed

Closed

2F8h (COM2:)

Closed

Open

Open

Closed

3E8h (COM3:)

Open

Closed

Closed

Open

2E8h (COM4:)

Closed

Closed

Open

Open

í Plug-N-Play

Open

Open

Open

Open

SUPPORTED STANDARD COMMANDS

Basic AT Commands

+++, ‘comma’, A/

A, C, D, E, H, L, M, Q, V

&C, &F, &K

Extended AT Commands

\G, \Q

%C

S-Registers

The S-registers are unidentified.

Note: See MHI help file for complete information.

Proprietary AT Command Set

EXTENDED RESULT CODES

Type:

Configuration

Format:

AT [cmds] Wn [cmds]

Description:

Selects the format of the CONNECT result code.

Command

Function

í W0

CONNECT result codes to report DTE speed.

W1

CONNECT result codes to report DTE speed.

W2

CONNECT result codes to report DCE speed.

W3

CONNECT result codes to report DTE speed and error correction/compression.

W4

CONNECT result codes to report DTE speed, modulation, and error correction/compression.