8 0 8 0 - 0 0 MICROSCIENCE NO MORE PRODUCED Native| Translation ------+-----+-----+----- Form 3.5"/SLIMLINE Cylinders 1768| | | Capacity form/unform 85/ MB Heads 2| | | Seek time / track 25.0/ ms Sector/track | | | Controller IDE / AT Precompensation Cache/Buffer KB Landing Zone Data transfer rate 1.000 MB/S int Bytes/Sector 512 MB/S ext Recording method RLL operating | non-operating -------------+-------------- Supply voltage 5/12 V Temperature *C | Power: sleep W Humidity % | standby W Altitude km | idle W Shock g | seek W Rotation RPM 3600 read/write W Acoustic dBA spin-up W ECC Bit MTBF h Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** MICROSC. 8XXX SERIES JUMPER SETTINGS 280094-004 REV. A +---------------------------------------------------------+ | |XX | |XXAT-BUS | |XXC | |XXO | |XXN | 8-+-+-+-+ P11 |XXN | +-+-+-+-1 |XXE | |XXC | |XXT | |XXO | |XXR | | | | | | | | | Bottom View | +---------------------------------------------------------+ ********************************************************************** J U M P E R S ********************************************************************** MICROSC. 8XXX SERIES JUMPER SETTINGS 280094-004 REV. A Jumper Setting ============== P11 --- 8 6 4 2 +--+--+--+--+ 1-2 Not-Used | | | | | 3-4 RESERVED +--+--+--+--+ 5-6 RESERVED 7 5 3 1 7-8 ON = SLAVE MODE ********************************************************************** I N S T A L L ********************************************************************** MICROSC. 7XXX/8XXX SERIES JUMPER SETTINGS 280095-004, REV. A Installation Procedure ---------------------- 1. Installation precautions --------------------------- Four (4) 6-32UNC screws, with 3/16" (4.78mm) maximum screw length, are required for installation. Use caution when installing the mounting screws to ensure no contact is made with drive's printed circuit board. 2. In the CMOS (System BIOS) setup, select drive type as follows ---------------------------------------------------------------- Select a hard drive type that is equal to or less than the formatted capacity of the drive. NOTE Drive parameters cannot exceed the specified capacity. - Use user defined type or manually enter the drive parameters. 3. Disk partion options ----------------------- Use DOS "FDISK" to create the partition table. Utility software such as Disk Manager or Speedstor may be used. 4. High Level Format Options ---------------------------- If DOS "FDISK" is used to create the partitions, then use DOS "FORMAT" to do the high level format. If Disk Manager is used to create the partitions, then use Disk Manager to do the high level format. If Speedstor is used to create partitions, then use Speedstor to do the high level format. Always low-level formatted at the factory!